![]() I've since temporarily connected two, 100 ohm 1W resistors in parallel to give me a resistance roughly in the middle of the expected range, and with a bit more ability to dissipate power. The burnt resistors were in series, and I believe they were in the range of 10 ohms to 100 ohms. I measured the voltage between the points just before and after where the resistors were, and I am seeing 12V DC. Problem is I'm too new to know which the answer might be so I'm hoping for some guidance here. To me this suggests either something else isn't working right in the circuit, or it was a bad design from the get-go. The main question is, it seems to me like the resistors that burnt are being made to dissipate quite a bit of power, and yet the originals where only 1/4W each.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |